Glen Fallot

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • in reply to: Module 4 unit 1 study guide #12159
    Glen Fallot
    Member

    ok, thanks for the tips im getting ready to take the test.

    in reply to: Module 4 unit 1 study guide #12156
    Glen Fallot
    Member

    a. How 240 vac is delivered to the appliance. My answer is by dropping 240v to 120v for L1 and 120v for L2. thing like heating elements will combine L1 and L2 creating the 240v they need to run.

    How to use voltage measurements to locate the fault in an electric dryer that is
    not heating. My answer is i would first check voltage at the source L1 to N for 120v and L2 to N for 120v then i would check L1 ands for L2 for 240 if yes then i would get the wiring diagram locate the heater coils and thermistor for proper voltage.

    I hope im on the right track?

    in reply to: Module 4 unit 1 study guide #12154
    Glen Fallot
    Member

    No current will not change it stays the same at every point

    in reply to: Module 3 unit 8 #12146
    Glen Fallot
    Member

    and is 8 [answer hidden]

    • This reply was modified 3 years, 1 month ago by Susan Brown. Reason: hid answer
    in reply to: Module 3 unit 8 #12145
    Glen Fallot
    Member

    on question 7 is the answer [answer hidden]

    • This reply was modified 3 years, 1 month ago by Susan Brown. Reason: hid answer
Viewing 5 posts - 1 through 5 (of 5 total)